Instructions in 7 steps The foam rubber hearts get a special mounting. The knotted cotton ribbons and the long tassel garner much attention. And this is how it works:
1 ![]()
Step 1
Cut out hearts according to the cutting pattern: 2× pink and 2× grey2 ![]()
Step 2
Make the yarn cuttings as follows: Pink: 2× 1.50 m (strand), Pink: 24× 14 cm + 1× 15 cm (tassel), Grey: 2× 1.50 m (strand), Grey: 24× 14 cm + 1× 15 cm (tassel)3 ![]()
Step 3
Tassel: Place the 24× 14 cm sections of yarn together and put it halfway in a loop, wrap the 15 cm long section around the loop at 1 cm and stick the end firmly.4 ![]()
Step 4
Place the 2× 1.50 m cotton yarns on top of each other and halfway.5 ![]()
Step 5
At approx. 2.5 cm, set the first reef knot. Then make a 7 cm long reef knot. Since the yarn is very soft, do not knot the knots too tightly.6 ![]()
Step 6
Then use the styrofoam adhesive to glue two pink-coloured hearts together, so that the strand with the yarns passes through centrally between them.7 ![]()
Step 7
Thread the strand of the last heart through the loop of the tassel and glue the end into the heart.Related craft ideas Looking for similar craft ideas? You can find them here: ![]()
![Difficulty -]()
![]()
![Difficulty -]()
![]()
![Difficulty -]()
![]()
![Difficulty -]()
Wire forms intriguingly wrapped
DIFFICULTY
Quilling Heart
DIFFICULTY
Heart garland rubber sponge
DIFFICULTY
Paper lantern pinkish with dots
DIFFICULTY